17 Product specifications are subject to change without prior notice. Embedded Peripherals Communication modules Galvanic Isolation and ESD protection The circuit design of our expansion cards use reliable transformers and transceivers to exchange information and power between high voltage areas and controllers. Through this design, the flow of current is denied a direct conduction path to the rear systems, thus preventing damage to your device. Innodisk isolation design complies with EN61000-4-5 surge protection and IEC 60950-1:2005 + A1: 2009 + A2:2013 HiPOT up to 2500V and our embedded peripheral cards provides a reliable Electrostatic Discharge Protection that complies with the EN61000-4-2 (ESD) Air-15kV, Contact-8kV standard. Controller Area Network Bus: A vehicle bus-standard that allows electronic control devices to communicate with each other without the presence of a host computer, allowing for a drastic simplification and reduction of on-board wiring. Model Name EMUC-B201 Module Type USB to dual isolated CANbus 2.0B module Key Features 1. mPCIe form factor. Two channels CANbus 2.0B(DB-9 x 2) backward compatible with 2.0A 2. Complies with EN61000-4-5 2.5kV Surge protection 3. Complies with IEC 60950-1:2005 + A1: 2009 + A2:2013 2.5kV HiPOT protection 4. Complies with EN61000-4-2 (ESD) Air-15kV, Contact-8kV 5. Supports -40 to +85 degrees 6. Supports 3rd mounting hole and USB Pin header for out-of-minicard installation 7. Supports baud rate 50/125/250/500/1000K 8. Termination resistor enabled/disabled by jumper Form-Factor mPCIe Input I/F USB 2.0 Input Connector mPCIe or 5Pin Header Output I/F CANbus 2.0B x 2 Output Connector DB-9 x 2 Dimensions(W*L*H/mm) 30.0 x 50.9 x 8.35 Operating Temperature Wide temp : -40°~85°C Order Info. EMUC-B201-W1 CANBus Rugged and Secure HiPOT ESD Surge Wide Temp Table of Contents